Mit der Veröffentlichung der Statikprogramme RFEM 6, RSTAB 9, RSECTION 1 und RWIND 2 leitet das Softwareunternehmen Dlubal Software eine neue Generation statischer Berechnungsprogramme ein. Getreu dem Motto „Statik, die Spaß macht…“ werden den Anwendern universelle Werkzeuge in die Hand gegeben, mit denen alle Anforderungen in der Tragwerksplanung bewältigt werden können. Was sich sonst noch bei Dlubal Software Neues getan hat, erfahren Sie in diesem Artikel.
Soll auf eine kegelförmige Bodenplatte eine partielle Auftriebslast aufgebracht werden, so bietet sich in RFEM die "freie Kreislast" an. Diese kann linear veränderlich definiert werden. Die Definition von Zentrum C und äußerer Berandung R ist komfortabel mit der Pickfunktion anzugeben.
Le présent article traite des éléments dont la section est soumise simultanément à un moment fléchissant, à un effort tranchant et à un effort normal de compression ou de traction. Cependant, dans notre exemple nous n'intégrerons pas de sollicitations dues à un effort tranchant.
The Steel Joist Institute (SJI) previously developed Virtual Joist tables to estimate the section properties for Open Web Steel Joists. These Virtual Joist sections are characterized as equivalent wide-flange beams which closely approximate the joist chord area, effective moment of inertia, and weight. Virtual Joists are also available in the RFEM and RSTAB cross-section database.
Requirements for the design of structural stability are given in the AISC 360 – 14th Ed. Chapter C. In particular, the direct analysis method provisions, previously located in Appendix 7 of the AISC 360 – 13th Ed., are described in detail. This method is considered an alternative to the effective length method, which in turn eliminates the need for effective length (K) factors other than 1.0.
如果您想在 RFEM 或 RSTAB 附加模块中设计结构构件,那么某些附加模块中提供了多个国家附录。 Werden die Bauwerke vorwiegend nach einem bestimmten nationalen Anhang berechnet, bieten die Zusatzmodule die Möglichkeit, einen Standardwert zu setzen. Damit wird es dem Anwender erspart, bei jedem neuen Modell den NA erneut auswählen zu müssen.
When defining nodal loads, you have several simple options to rotate them:~ Rotation by means of an angle around the global coordinate axes in a certain order~ Orientation at a user-defined coordinate system~ Direction to a particular node~ Alignment by means of两个节点~在杆件/线的方向上